Kawasaki KRX H2 Vehicle Lift Guide
Safely lift your Kawasaki KRX H2 using the AGM Electric Jack PRO. Tested on a real vehicle during real trail repairs.
Estimated Read Time: 1–2 Minutes
Quick Answers
★★★★★ Preferred Rear Lift: Trailing arm
★★★★★ Preferred Front Lift: Upper control arm
★★★★☆ Alternate Rear: Rear chassis tube beneath the engine
★★★★☆ Stability Tip: Rotate the collar 90 degrees during front lifts if the jack begins to pivot
Avoid: Plastic body panels, unsupported skid plates, hot exhaust components, unstable ground.
You're in the Right Place If...
• You have a flat tire on a Kawasaki KRX H2.
• You want the safest lift points.
• You're using an AGM Electric Jack PRO.
• You want to avoid damaging your vehicle.
• You want to get back on the trail quickly.
Flat Tire Repair
• If using hand tools, loosen the lug nuts before lifting.
• Lift from the preferred lift point.
• Place a cooler, toolbox, spare tire, or similar size solid object under the vehicle as a secondary support.
• Remove the lug nuts, catching each one if possible.
• If a lug nut falls into dirt or sand, clean it before reinstalling so threads are not damaged.
• Install the replacement wheel.
• Start every lug nut by hand.
• Tighten in a star pattern.
• Torque to Kawasaki specifications whenever possible. If a torque wrench is not available, tighten with an impact gun to get you home.
Preferred Rear Lift
Lift Here
Flat section of the trailing arm just forward of the radius in the arm.
Why
• Preferred rear lift point for the AGM Electric Jack PRO.
• Reduces required lift height.
• Helps keep the lifting pad engaged.
• Creates a stable rear lifting position.
Watch Out
• Position the lifting pad on the flat section of the trailing arm.
• Push the jack inward until the jack body contacts the side of the suspension.
• Create two points of contact before lifting.
Trail Tip
Keep the lifting pad slightly farther underneath the vehicle than the top of the jack so it moves toward vertical as the vehicle rises.
Alternate Rear Lift
Lift Here
Rear chassis tube beneath the engine.
Why
• Good backup if the trailing arm cannot be used.
• Solid structural lift point.
• Allows stable vehicle support during repairs.
Watch Out
• Position the jack between the shock and radius rods.
• Allow the exhaust to cool before working in this area.
• Keep the battery away from hot exhaust components.
Trail Tip
Push the jack fully inward until you establish multiple points of contact before lifting.
Preferred Front Lift
Lift Here
Flat section of the upper control arm just past the bend.
Why
• Preferred front lift point for the AGM Electric Jack PRO.
• Stable lifting surface.
• Helps minimize required lift height.
• Dual contact helps stabilize the lift.
Watch Out
• Point the jack toward the center of the vehicle.
• Position the lifting pad perpendicular to the face of the control arm.
• Lightly contact the lower control arm with the jack body.
Trail Tip
Create two points of contact before lifting: the lifting pad on the upper control arm and the jack body lightly against the lower control arm.
Stability Tip
Lift Here
Use the same front upper control arm lift point after rotating the collar.
Why
• Reduces unwanted pivoting during front lifts.
• Limits side-to-side movement.
• Keeps the jack aligned with the lift point.
• Creates a more controlled lift.
Watch Out
• Rotate the adjustment collar 90 degrees before lifting.
• Verify the jack remains aligned with the lift point.
• Lower and reset the jack if it begins to shift.
Trail Tip
Rotating the collar can make front lifting noticeably easier on the KRX H2.
Common Mistakes
• Lifting from unsupported skid plate areas.
• Positioning the jack so it leans farther under the vehicle as it rises.
• Letting the battery contact hot exhaust components.
• Forgetting to rotate the collar when front lift movement becomes an issue.
• Starting lug nuts with an impact.
• Crawling under a vehicle supported only by a jack.
Trail Safety Checklist
✓ Move off the trail whenever possible.
✓ Park on level ground.
✓ Vehicle in Park.
✓ Four-wheel drive engaged if needed.
✓ Chock a tire if necessary.
✓ Use a secondary support before putting any part of your body underneath the vehicle.
Questions We Hear Most
Where should I lift a Kawasaki KRX H2 with an Electric Jack PRO?
For most repairs, lift from the rear trailing arm and front upper control arm.
What is the best rear lift point on a Kawasaki KRX H2?
The trailing arm is the preferred rear lift point. The rear chassis tube can also be used when needed.
What is the best front lift point on a Kawasaki KRX H2?
The upper control arm is the preferred front lift point when using the AGM Electric Jack PRO.
Why should I rotate the adjustment collar 90 degrees?
Rotating the collar can reduce unwanted pivoting during front lifts and help keep the jack aligned with the lift point.
Why should I keep the battery away from the exhaust?
The exhaust can stay hot after driving, so keep the battery positioned where it cannot contact hot exhaust components.
How do I safely lift a Kawasaki KRX H2 on the trail?
Move to flat ground whenever possible, place the vehicle in Park, chock a tire, and use a secondary support if you may need to work underneath the vehicle.
Continue Learning
Watch
▶ Watch the Kawasaki KRX H2 Lift Video
Explore Other Lift Guides
Manual Jack PRO Vehicle Lift Guide
Manual Jack Sport Vehicle Lift Guide
Scissor Jack Vehicle Lift Guide
AGM Jacks For This Vehicle
Learn More
Choosing the Right AGM Trail Jack (Coming Soon)
Premium Off-Road Jacks That Make Recovery Safe and Simple.
Because how you lift it matters.
